Gamiviti 60" 1x2 Extrusion Cross Bars - cross bars only

In general the 60" length is a good starting point for most roof racks, at it allows a little bit of overhang on the sides of the rack.

Uses of extrusion cross bars include...

Create a support for your roof tent lift system. If you have a Racor, Fleximount, or other lift system in your garage for raising and storing your RTT, you simply loop those cables around the ends of these extrusions to lift it.

Create a side rail to secure loads on your rack using 40mm extrusions. These extrusion cross bars can mount both across the rack, or lengthwise.

Mount cross bars directly to Gamiviti towers- for light duty applications where a full rack isn't required, or if you're waiting for your full rack to be built, you can use these cross bars on your Gamiviti towers to get you by and out the door.

Mount cross bars to Multi Brackets- for even more versatility, you can mount these extrusion cross bars to our Multi Brackets, providing a more raised cross bar system on your Gamiviti rack, or using the Multi brackets on a trailer. This allows you a fast solution to transfer a roof tent between your roof rack and offroad trailer, for example.

Below are a some pictures that show you these installed.

• Option: 2 cross bars ($185.00), 3 cross bars ($285.00)
• Specify Length: 60", Other length
• length request:: tell us when ordering