Gamiviti Case install kit - Select quantity

As seen above, we've developed a fairly innovative method of installing plastic cases to Gamiviti racks, using a combination of our plastic clips, snap pins, and cinch straps. Shown here with the Apache 4800 case from Harbor Freight, this solution is applicable to a variety of cases on the market. Here are the instructions.. you can refer to this list while you watch the video below.

Determine where on your rack the case is going to go, relative to the rack cross bars and adjacent plates. Figure out the best place to run the strap, and where the clips will be grabbing onto the rack.

Install the pins through the side of the case by drilling 1/4" holes, putting the pin as high on the ribs as you can without interfering with the latch function.

Install the plastic clips to the bottom of the case, taking care to miss any raised ribbing. Drill holes and install plastic clips for one of the cross bars first, followed by adding the other row of clips. Measure the gap between the cross bars you are using, then subtract 1" from that measurement for the location of your second set of holes.

Example: most cross bars have a 9.5" gap between them, so your two rows of clips will have holes drilled 8.5" apart.

Tighten the plastic clips so that their radii are fully engaged with the cross bars, and the case is held in place without any lateral movement front to back. Add the cinch strap to tighten the case down tight to the rack, and prevent lateral movement side to side.

Case install kit

We've assembled all of the pieces used in the modification of the Apache 4800 case and put them in one kit. The kit contains 2 1/4" snap pins, 4 plastic clips, 8 1/4-20 bolts, washers, and flange nuts, and 1 cinch strap. These are all the pieces you need if you'd like to follow along with the video, and replicate the same case install on your Gamiviti rack.

• Option: 1 kit ($25.50), 2 kits ($45.00)